Structural, mechanical, dielectric properties and magnetic interactions in Dy3+-substituted Co-Cu-Zn nanoferrites.

Sol-gel-synthesized Co-Cu-Zn ferrite nanoparticles diluted with Dy3+ ions were investigated in terms of their structural, morphological, elastic, magnetic and dielectric properties. X-ray diffraction patterns showed the formation of a single-phase cubic spinel structure. As the concentration of Dy3+ ions was increased, the lattice length gradually increased from 8.340 to 8.545 Å, obeying Vegard's law. The Williamson-Hall (W-H) method was employed to observe the change in the lattice strain. Crystallite size obtained from W-H plots followed a pattern similar to that observed using the Scherrer equation. The cation distribution suggested a strong preference of Dy3+ ions for the octahedral B site while Cu2+ and Fe3+ ions were distributed over both A and B sites. The microstructures of the samples were visualized using transmission electron microscopy. Mechanical properties such as stiffness constant, longitudinal and transverse wave velocities, Young's modulus, bulk modulus, rigidity modulus, Poisson's ratio and Debye temperature were investigated by acquiring infrared spectra recorded in the range of 300 to 800 cm-1. Replacement of Fe3+ ions with the strongly magnetic Dy3+ ions increased the saturation magnetization and coercivity. Dielectric constant increased with Dy3+ substitution but decreased with applied frequency.

Polycrystalline to preferred-(100) single crystal texture phase transformation of yttrium iron garnet nanoparticles.

Nanocrystalline Ce-substituted yttrium iron garnet (YIG) powders of different compositions, Y3-x Ce x Fe5O12 (0 ≤ x ≤ 2.0), were synthesized by a combination of sol-gel auto-combustion and solid-state synthesis techniques. The as-obtained powder samples were sintered at 1150 °C for 10 h. The garnet structure formation is confirmed by the X-ray diffraction pattern, which shows that the calculated lattice parameter increased for x = 1.0 and shows a decreasing trend for x ≥ 1.0 with the addition of cerium ions. The lattice parameter increased from 12.38 Å to 12.41 Å for x ≤ 1.0 whereas it decreased from 12.412 Å to 12.405 Å with the cerium composition for x > 1.0. The average particle size determined by high resolution transmission electron microscopy is in the range of 50 to 90 nm and found to increase with the substitution of cerium ions in YIG. The room temperature magnetic parameters such as saturation magnetization, coercivity and remanence magnetization are greatly affected by the substitution of cerium ions. The values of saturation magnetization decrease from 25.5 to 15 emu g-1 whereas coercivity increases from 1 to 28 Oe with the substitution of cerium ions. The pure YIG sample shows polycrystalline nature that changed towards a single-crystal structure leading to a preferred-(100) orientation with the Ce substitution. The change from a ring to a spotty pattern observed in SAED confirmed the crystalline phase transformation and is well supported by HRTEM and magnetic measurements. The behavior of magnetic and electrical properties is well supported by the poly- and single-crystalline nature of YIG and Ce-YIG, respectively. The crystal structure transformation in YIG brought about by Ce substitution could unveil enormous opportunities in the preparation of single-crystal materials from their polycrystalline counterparts.

Effect of La3+ Impurity on Magnetic and Electrical Properties of Co-Cu-Cr-Fe Nanoparticles.

In this work a series of Co0.7Cu0.3Cr0.5La(x)Fe1.5-(x)O4 were synthesized via sol-gel auto-combustion technique through the incorporation of La3+ into the raw powders. The structural magnetic and resistivity properties of the synthesized Co-Cu-Cr-La ferrites were investigated. X-ray diffraction data indicated that, after La3+ doping, samples consisted of the main spinel phase in combination with a small amount of a foreign LaFeO3 phase. The addition of La3+ resulted in the reduction of particle size and an increase of porosity of the synthesized samples. The infrared spectra were recorded on the range from 300-800 cm(-1). The two primary bands corresponding to tetrahedral v1 at 595-605 cm(-1) and octahedral v2 at 389-413 cm(-1) were observed. The octahedral site radii increased rapidly with La3+ substitution while the tetrahedral site radii slowly increased. Deviation from the ideal oxygen positional parameter is found to decrease with La3+ substitution. The saturation magnetization of the samples decreased with the amount of La3+ ions doped and the coercivity shows an opposite trend. La3+ substitution affects the hopping between Fe2+ <-> Fe3+, resulted in increase in resistivity.

Al3+ ions dependent structural and magnetic properties of Co-Ni nano-alloys.

Ferrite samples with a chemical formula Co0.5Ni0.5Al(x)Fe(2-x)O4 (where x = 0.0, 0.25, 0.5, 0.75 and 1.0) were synthesized by sol-gel auto-combustion method. The synthesized samples were annealed at 600 degrees C for 4 h. An analysis of X-ray diffraction (XRD) patterns reveals the formation of single phase cubic spinel structure. The lattice parameter decreased linearly with the increasing Al content x. Nano size of the powders were confirmed by the transmission electron micrographs (TEM). Particle size, bulk density decreased whereas specific surface area and porosity of the samples increased with the Al substitution. Cation distribution of constituent ions shows linear dependence of Al substitution. Based on the cation distribution obtained from XRD data, structural parameters such as lattice parameters, ionic radii of available sites and the oxygen parameter 'u' is calculated. Saturation magnetization (M(s)), magneton number (n(B)) and coercivity (H(c)) decreased with the Al substitution. Possible explanation for the observed structural and magnetic behavior with various Al content are discussed.